The answer to my last question is well documented in the forums. I apologize for not seeing it in my admittedly quick searches. I have copied Ami's method here in case any one else is wondering.
Ami said:
Quote:
For my preplant dip solution I get a small bucket 1 1/2 to 2 gallon in size. Add I gallon of water and dissolve 1/4 tablet Biota Max in the water. Then add 2 teaspoons of Actinovate and 2 Teaspoons of Mycogrow soluable to the solution and mix well.
Now submerge the pot of the seedling just below the surface of the water to fill the pot with the solution, remove and allow the pot to drain back into the bucket. Then remove the seedling from the pot if plastic type was used or plant the pot w/seedling if Dot Pot Or Cow Pots were used.
Just be careful when dipping the pot in the solution as you want to retain as much aggregate in the pot as possible rather than have it float out of the pot and into the dip bucket.
During the dipping operation periodically agitate the water to keep the ingredients mixed in the solution. When your done apply the left over dip to the plants you have just planted. The above instructions are assuming you are using 4" pots or less in size. Ami
|