View Single Post
Old October 21, 2016   #160
Worth1
Tomatovillian™
 
Worth1's Avatar
 
Join Date: Feb 2006
Location: Den of Drunken Fools
Posts: 38,547
Default

Here is an example of a MT 3 taper with 30 degrees at the top and 1 degree 26 minutes at the bottom.
I cant believe that drill press could be out that much and not be adjustable that is flabbergasting.
Is the tilt from side to side or front and back?
Was the table locked down?
Most drill presses have a side to side adjustment but no front to back.
Mine has both.


Last edited by Worth1; October 21, 2016 at 01:55 PM.
Worth1 is offline   Reply With Quote