View Single Post
Old October 22, 2016   #162
Fusion_power's Avatar
Join Date: Feb 2006
Location: Alabama
Posts: 2,154

I pulled out the user manual and figured out how to adjust the drill head. It took about 10 minutes to fix. Worth, I used your trick with a bent shaft to verify it is correct! I will still use the jig, but I cut it to a properly flat wood piece. It gives me a nice backstop to hold the pieces I am drilling. I think of it as a smaller version of screwing a piece of wood to the rip fence on a table saw.
Fusion_power is offline   Reply With Quote