Quote:
Originally Posted by MrSalvage
14.7 @ sea level....
or
14.696 psi
From my engine building classes...
I know you were just rounding it off in laymen's terms.
|
Yes I was just rounding off.
Just like my lathe says I cant cut 11.5 threads per inch but I can if I convert it to metric threads or at least get so close it doesn't matter with a gear swap.
Pitch in inches 0.08696 converted to metric is 2.209 MM.
The lathe will cut 2.2.
This is less than run out or imperfections.
Worth