Now that it is here I cant wait to get started.
I haven done nor bought anything yet to do it.
I completed converting it over to LPG and it was sort of a pain.
The regulator was no problem.
One of the LPG jets fell out of my nut driver and into the cavity of the cook top.
There is no way to even see where it went.
I finally took all 5 burner knobs off and shook the cook top over my head and the jet fell into my shirt pocket.
They have little springs on them to keep this from happening but this one was a little lose.
Then the very last simmer burner was so small my other wee socket wouldn't fit the top of the hex head screw that holds it on and the hole in the top is the only one that is too small for the socket to fit into.
I had to take the socket to the grinder and turn it down so it would fit in this wee space.
I plugged it in and tested all of the igniters to make sure they work.
Anyway it is now converted to LPG gas.
All I need to do is when I get gas to it is adjust the flames.
The knobs are some kind if good steel because they ring when you tap them.
In the pictures you can see the hole where the jet goes and the two wee screws.
Worth
IMG_20160616_55656.jpg
IMG_20160616_8143.jpg