Here they are took my sweet time doing it because I only had one shot at drilling holes correctly in the tail stock.
I drilled them with the tail stock upside down.
The homemade T Nuts fit perfectly in the T slots.
In the first pictuer you will see where I drilled and tapped the plate to attach on cap screw.
Then I went on and did them one at a time making sure everything was in alignment.
Once all were drilled and set I then drilled out the tapped portion to a bigger size to allow for wiggle room to make for perfect alignment with the other part of the contraption.
IMG_20190502_45660.jpg
IMG_20190502_925.jpg
IMG_20190502_23807.jpg