View Single Post
Old May 2, 2019   #354
Worth1's Avatar
Join Date: Feb 2006
Location: Den of Drunken Fools
Posts: 38,547

Here they are took my sweet time doing it because I only had one shot at drilling holes correctly in the tail stock.
I drilled them with the tail stock upside down.
The homemade T Nuts fit perfectly in the T slots.

In the first pictuer you will see where I drilled and tapped the plate to attach on cap screw.
Then I went on and did them one at a time making sure everything was in alignment.
Once all were drilled and set I then drilled out the tapped portion to a bigger size to allow for wiggle room to make for perfect alignment with the other part of the contraption.



Last edited by Worth1; May 2, 2019 at 06:51 PM.
Worth1 is offline   Reply With Quote