Quote:
Originally Posted by Fusion_power
My 40+ year old Craftsman table saw made a lot of noise from vibration. This was unnecessary noise caused by the insert on top of the saw vibrating when the motor was running. The insert is held down by a screw on one end and by a spring steel retainer at the other end. The spring steel retainer cannot be tensioned enough to make the insert stop vibrating. The noise it made was louder than the motor!
I fixed the problem by drilling the end for the spring retainer all the way through the cast iron table, then chamfered and threaded the hole for a 10-32 machine screw. I then slotted the end of the insert so I can push it under the screw and tighten it down. The result is a noise reduction to a level better than when it was new.
|
Nothing I hate worse that a rattling table saw or one with a ringing blade.
Worth