Information and discussion about canning and dehydrating tomatoes and other garden vegetables and fruits. DISCLAIMER: SOME RECIPES MAY NOT COMPLY WITH CURRENT FOOD SAFETY GUIDELINES - FOLLOW AT YOUR OWN RISK
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Tomatovillian™
Join Date: Jan 2006
Location: S. FLorida / Zone 10
Posts: 369
|
![]()
"Farkee,
the pressure canner purchase really deserves a thread of its own. I need to buy one. " Clay 199 I agree, down here the 3 main choices seem to be Presto, Mirro, and All-American. I have researched all 3 and 'think' I have come to a conclusion. You have to decide on the gauge or weight kind and then you have to take into consideration if you have a glass-top stove. Do you have any other brands available in Canada?
__________________
"When we kill off the natural enemies of a pest we inherit their work." Carl Huffaker |
![]() |
![]() |
![]() |
#2 |
Tomatovillian™ Honoree
Join Date: Jan 2006
Location: Wynndel, BC, CANADA
Posts: 78
|
![]()
Owing three, I would rank them as follows:
All-American with a gauge. Big enough for 2 layers of 7-8 pint size jars, or 7 quarts. All- American with gauge. Holds 7 pint or quart jars. Presto with bell gauge which holds 4 pints. The bell gauge is the easiest to use, but you must be right on top of it and it doesn't allow you to adjust for atmospheric pressure changes. Val |
![]() |
![]() |
![]() |
#3 |
Tomatovillian™
Join Date: Feb 2006
Location: SW Ontario Zone 5b
Posts: 35
|
![]()
I'm going to need to dig out my pressure canner and see what make it is. My parents found it for me, and I haven't yet had an opportunity to use it (it will have a new gasket etc in place before I use it
![]() I think it is an all american though, and I'm very excited about the upcoming canning season and getting to use this beasty finally! Cindy ![]() |
![]() |
![]() |
![]() |
#4 |
Tomatovillian™
Join Date: Jan 2006
Location: S. FLorida / Zone 10
Posts: 369
|
![]()
I really don't want a gauge type as you have to have it tested every year but will probably have to go that route. There is no where to do that testing as this very urban area where canning seems to have gone the way of the dinosaur.
All-american says not to use it on a glass-top stove (which I have). Mirro, which has the weight thing which I prefer because you don't have to have it tested. also says not to use on glass-top stove. That leaves only Presto , the only make that says it is OK on my kind of stove but it has the gauge. I do have a big camp stove (gas) --so if I wanted to do it all outside I could get any of the above I guess. GRUNGY, what do you mean by a bell gauge and that you have to be right on top of it? DO you have to stay by the stove and check it all the time?
__________________
"When we kill off the natural enemies of a pest we inherit their work." Carl Huffaker |
![]() |
![]() |
![]() |
#5 |
Tomatovillian™ Honoree
Join Date: Jan 2006
Location: Wynndel, BC, CANADA
Posts: 78
|
![]()
A bell gauge is a weighted gauge which rocks back an forth when the canner gets up to the pressure the gauge is set for. As it rocks back and forth it looses a wee bit of steam. They have a tendency to be slightly more "cranky" about keeping the pressure even, at least in my experience. During the year I usually can about 1200 jars of all sorts of food, so when canning season starts, I really don't have time to stand beside the stove and keep a hawk eye on the gauge every second. With my dial gauge, I get it up to pressure, set my timer and go on to the preparation of the next batch. As for having the gauge checked every year - after faithfully doing that for 5 years and finding that it ran true each time I now have it done every 2 to 3 years. It still hasn't needed adjustment after 16 years. If you knock it on something or fail to clean it from time to time, then it might be wise to check it annually. Hope this helps.
Val |
![]() |
![]() |
![]() |
#6 |
Tomatovillian™
Join Date: Jan 2006
Location: Beyond Hope, British Columbia
Posts: 201
|
![]()
Val et al,
How much time does a pressure canner take to process? I have used water baths, and the 45 minutes time kills me. Is it worth paying the extra money to purchase one that does 14 quarts as opposed to 7 quarts? I know it is safer, which is why this year we will purchase one. thanks, Clay |
![]() |
![]() |
![]() |
#7 |
Tomatovillian™ Honoree
Join Date: Jan 2006
Location: Wynndel, BC, CANADA
Posts: 78
|
![]()
Hi Clay,
I find that it generally takes about 2/3 the time of the water bath and my water bath only holds 7 quarts, so if you can get one that hold 14 quarts and do a lot of canning it should work out to some where between 1/3 and 1/2 the time. (mathematically 1/3 but with the extra preparations of an additional 7 quarts - 1/2.) Hope this helps make your decision and if you are planning on canning the following: fish, meat, chicken or beans, pressure canning is definitely the way to go. Cheers, Val |
![]() |
![]() |
![]() |
#8 |
Tomatovillian™
Join Date: Jan 2007
Location: upper northern California
Posts: 7
|
![]()
Howdee
about 10 yrs ago a friend of mine gave me her old canner an old all american canner. It was so big with its clamps. Just sitting there on the counter like an evil beast. Soo I said good ness girl your scared of a hunk of metal. The canner set on my counter for about two week with me just staring at it. Then I finally gave it a try. I could can huge amounts of food in it with its double layer. Well about 5 years ago I bought a smaller all american canner single layer type. This last year I canned over 700 jars of food in my all american canner. I even can my tomatoes in my canner no water bath for me. I use the recipe via the newer all american canner booklet that came with my single layer canner. It works for me ![]() ![]() Purpleacres |
![]() |
![]() |
![]() |
#9 |
Tomatovillian™
Join Date: May 2006
Location: Lexington, KY
Posts: 213
|
![]()
Do any of y'all use your canner on a glass top range? I have read somewhere that you're not supposed to set them down directly on a glass-top, but I don't know why.
|
![]() |
![]() |
![]() |
#10 |
Tomatovillian™ Honoree
Join Date: Mar 2007
Posts: 507
|
![]()
hunter, you should not use any canner on a glass top as far as I know. The glass is not rated for that kind of weight.
One of the early posters on this thread mentioned that she has one of the large gas rings intended for use with an aparatus for deep-frying turkeys outdoors that she uses. Has it set up in the garage, which would also solve the problem of overheating the kitchen. Last time I saw one of those was at a camper's supply store, but I suspect you might even find one at WalMart in much of the country. |
![]() |
![]() |
![]() |
#11 |
Tomatovillian™
Join Date: Mar 2006
Location: Southern Ohio
Posts: 170
|
![]()
I use my 8 quart pressure cooker on my ceramic cook top all the time.
You just have to buy a pressure cooker that is Stainless Steel and not aluminum and it has to have a thick bottom (like one of the multi-layered ones). The reason for the warning about not using them on ceramic cook tops is that the aluminum ones and the ones with thin bottoms distort the shape of the bottom when they are under pressure and bulge out. When they bulge out they are not in contact with the cook top surface and will not work properly because the heat is not tranferred correctly. This goes for all other cookware as well, especially skillets. I had to give away 3 skillets that were not perfectly flat on the bottom because they would not heat evenly and just got hot in one little spot where it touched the cook top. I have also found out that regular aluminum cookware will leave metallic scuff marks on the ceramic cook top that are really hard to remove. Hard Anodized Aluminum is ok though. As far as weight goes, I have had my 20 quart stock pot full of Brunswick Stew many times and it has never presented a problem. I have never heard of any weight restrictions (within reason) for ceramic cook tops either. They are actually ceramic, not glass. Hope this helps.
__________________
"To wander this country and this world looking for the best barbecue — and never actually finding it would be a life well spent, a delicious journey in which enlightenment comes with the search — not the arrival." - Anthony Bourdain Last edited by ZBQ; May 2, 2007 at 12:27 AM. Reason: forgot something |
![]() |
![]() |
![]() |
#12 |
Tomatovillian™
Join Date: May 2006
Location: Lexington, KY
Posts: 213
|
![]()
ZBQ- Thanks for the info! What brand do you use/recommend?
|
![]() |
![]() |
![]() |
#13 |
Tomatovillian™
Join Date: Jan 2006
Location: Texas
Posts: 3,027
|
![]()
In general, I agree with ZBQ's take on the matter regarding ceramic cooktops and how to properly pressure can on one.
Just be aware that the majority of the manufacturers specifically state that any warranties don't cover usage of pressure canners. |
![]() |
![]() |
![]() |
#14 |
Tomatovillian™
Join Date: Mar 2006
Location: Southern Ohio
Posts: 170
|
![]()
Well, I bought mine from QVC. I can't get the link to work right but this is the item number from it. Do a search for it at QVC and you will find it.
Item # K0828 Just a thought, this is a pressure cooker and not a canner in particular. I can fit pints in it but not quarts. I don't own a pressure canner per se but the principles involved (i.e. flat, thick bottom, not aluminum body) apply to all cookware used on a ceramic cook top. Something else I thought of was I have a Calphalon hard anodized square griddle pan that I received as a X-mas gift from the MIL last year that is nice and flat, but, once you start heating it, it warps like a daggone cookie sheet because the bottom is too thin! Then when it cools off it goes back to flat! It just remided me yet again why I should shop for my own kitchenware! I am VERY, VERY particular in that dept., just ask my wife!! ![]() ![]() ![]()
__________________
"To wander this country and this world looking for the best barbecue — and never actually finding it would be a life well spent, a delicious journey in which enlightenment comes with the search — not the arrival." - Anthony Bourdain |
![]() |
![]() |
![]() |
#15 |
Tomatovillian™
Join Date: Jan 2006
Location: SW Ohio
Posts: 1,278
|
![]() Cookware for Glass-Ceramic Cooktops We do not recommend glass or ceramic cookware for use on your glass-ceramic cooktop
- Put an inch of water in the pan. - Place the pan on the cooktop and turn it on HIGH. - If the water bubbles evenly around the pan, you can count on good performance. - If the water bubbles unevenly then that means there are hot spots and poor heat distribution is likely to occur.
__________________
"Seriously think about what you're about to do/say before you do it and the outcome will always be better." Earl |
![]() |
![]() |
![]() |
|
|