hose repair

habitat_gardener · February 22, 2020

Is it possible to repair a hose and make it leakproof?
This is for a new hose that was cut to a specific length.
We tried 2 different repair kits and the hose still leaks.

zeuspaul · February 22, 2020

I assume a standard garden hose? Where is it leaking? I use hose fittings from McMaster Carr. They are of better quality than what I can get from the local home improvement stores.

Black Krim · February 22, 2020

We often repair old hoses. Never leaks at the repair. Perhaps because my hoses are so old, it makes a leak in a new location.

For what its worth, we buy whatever is available at Ocean State Job Lot, a discount store. Peices fit into tubing VERY tight and bracket is screwed around insert before and after splice.

Nothing more agrivating than a leaky hose.

GoDawgs · February 22, 2020

If it's leaking at either end, have you changed the washer in the female connector or in whatever it is you're screwing on to the male connector? Sometimes that's the problem. I can't stand the cheap plastic washers sold today. Give me the good old rubber washers any time for a tight fit.

habitat_gardener · February 23, 2020

The hose was cut by my garden helper

[against my advice] so that I would have a hose connection in the exact center [not my idea] of the community garden plot. It leaks at the end, which is both where it was cut and where it connects to the next hose. I will recheck the washers; I have a good supply of the rubber ones.

GoDawgs · February 23, 2020

Quote:

Originally Posted by habitat_gardener

It leaks at the end, which is both where it was cut and where it connects to the next hose.

I've had that happen and sometimes it's because the end was cut unevenly. Check that too and re-cut or trim if needed. Also make sure the hose end is jammed up tightly against the rim of the fitting and that the clamp is as far up as it will go too and very tight.

Sometimes the clamps they come with are the guilty party, especially the clamshell type clamp where the two halves are screwed together. If that's the case, get a small radiator hose type clamp and try that.

I've found that Gilmour hose fix-its and most of their other products work well and are long lasting. There's always an exception but generally I've been satisfied even though their hose fix-its are a bit more expensive than the cheapies.

whoose · February 24, 2020

Go to your hardware store and tell them you want the brass repair you have to hammer into place, never leaks. Be sure to know the diameter or better take a piece with you.

February 22, 2020	#1
habitat_gardener Tomatovillian™ Join Date: Apr 2008 Location: California Central Valley Posts: 2,486	hose repair Is it possible to repair a hose and make it leakproof? This is for a new hose that was cut to a specific length. We tried 2 different repair kits and the hose still leaks.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

February 22, 2020	#2
zeuspaul Tomatovillian™ Join Date: May 2007 Location: North County, San Diego Posts: 370	I assume a standard garden hose? Where is it leaking? I use hose fittings from McMaster Carr. They are of better quality than what I can get from the local home improvement stores.

February 22, 2020	#3
Black Krim Tomatovillian™ Join Date: Dec 2016 Location: New England Posts: 661	We often repair old hoses. Never leaks at the repair. Perhaps because my hoses are so old, it makes a leak in a new location. For what its worth, we buy whatever is available at Ocean State Job Lot, a discount store. Peices fit into tubing VERY tight and bracket is screwed around insert before and after splice. Nothing more agrivating than a leaky hose.

February 22, 2020	#4
GoDawgs Tomatovillian™ Join Date: Feb 2018 Location: Augusta area, Georgia, 8a/7b Posts: 1,530	If it's leaking at either end, have you changed the washer in the female connector or in whatever it is you're screwing on to the male connector? Sometimes that's the problem. I can't stand the cheap plastic washers sold today. Give me the good old rubber washers any time for a tight fit.

February 23, 2020	#5
habitat_gardener Tomatovillian™ Join Date: Apr 2008 Location: California Central Valley Posts: 2,486	The hose was cut by my garden helper [against my advice] so that I would have a hose connection in the exact center [not my idea] of the community garden plot. It leaks at the end, which is both where it was cut and where it connects to the next hose. I will recheck the washers; I have a good supply of the rubber ones.

February 24, 2020	#7
whoose Tomatovillian™ Join Date: Mar 2015 Location: Bozeman, Montana Zone 6b Posts: 325	Go to your hardware store and tell them you want the brass repair you have to hammer into place, never leaks. Be sure to know the diameter or better take a piece with you.